Adjust the punch margin based on your document size. As a general rule, the thicker a book is, the larger the punch margin should be.Set the side guide so that your document will be centered within the punching throat.Align the edges of your document by either tapping them repeatedly against a flat surface or by placing them in a paper jogger.Insert your document into the punching throat. The ETitanWire has a 25 sheet maximum punch capacity (based on regular 20 lb. paper; using thicker sheets or cover stock will reduce the capacity), though most users choose to punch between 12 and 20 sheets at a time for optimum performance. Align the sheets so that they are flush against the back wall of the punching throat and the side guide.Step on the foot pedal to punch the document. Repeat punching in sets until all of the pages have been punched.Set the Enameled Wire closer's measurements based on the size of the binding Enameled Wire being used. Insert an empty Enameled Wire into the closer and pull the closer handle. Adjust the Enameled Wire closer settings and test as necessary until the Enameled Wire is closed appropriately.
Assemble all of the punched sheets into a complete book, placing the bottom page on the top of the stack. Place the punched edge so that it is facing you and slightly hangs over the edge of your work surface.Insert the Enameled Wire into the holes, starting at one side and working toward the other. As you progress, you will find that the prongs will fall naturally into the holes.Once the Enameled Wire has been inserted into all of the holes, carefully turn it so that the open ends face you and the solid side is through the holes.Carefully lift the document off of the working surface, making sure that the Enameled Wire stays in place. Lower the book straight down into the Enameled Wire closing mechanism, so that the open ends of the Enameled Wire are flush against the bottom of the Enameled Wire closers.Pull the handle to close the Enameled Wire and bind the book. Return the handle to its original position.Remove the book from the Enameled Wire closer, and turn the back page to the back of the document. This will conceal the seam of the Enameled Wire spine within the document and will give it a more professional finish.